SPARKY PMB 1200CE Instrucciones De Uso Originales página 8

cessories will normally break apart during
h)
Depending on application, use face
shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hearing
protectors, gloves and workshop apron
capable of stopping small abrasive or
workpiece fragments. The eye protection
trating particles generated by your opera-
i) Keep bystanders a safe distance away
from work area. Anyone entering the
work area must wear personal protec-
Use clamps or a vice to secure your
work whenever possible.
Do not apply side pressure to stop the
pad rotation after switching the machine
off.
Guide the machine towards the proc-
essed material only if the machine is
switched on.
k) Position the cord clear of the spinning
accessory. If you lose control, the cord
may be cut or snagged and your hand or
arm may be pulled into the spinning acces-
sory.
l) Never lay the power tool down until the
accessory has come to a complete stop.
The spinning accessory may grab the sur-
face and pull the power tool out of your con-
m) Do not run the power tool while carrying
it at your side. Accidental contact with the
spinning accessory could snag your cloth-
n) Regularly clean the power tool's air
vents. The motor's fan will draw the dust
inside the housing and excessive accumu-
lation of powdered metal may cause electri-
o)
mable materials. Sparks could ignite these
p)
uid coolants may result in electrocution or
6
EN
Fragments of workpiece
Using water or other liq-
This power tool is designed for dry
sanding only.
The tool must be used only for its pre-
scribed purpose. Any use other use
than those mentioned in this Instruction
will be considered a case of misuse. The
user and not the manufacturer shall be li-
The manufacturer shall not be liable for
any changes made to the tool nor for any
- damage resulting from such changes.
When operating in dusty environment,
the ventilation slots must be kept clean.
If it should become necessary to clear
mains supply (use non metallic objects
to clean the dust) and avoid damaging
internal parts. The power tool will over-
heat under deteriorated cooling due to the
-
Power tools must not be used outdoors
in rainy weather, or in moist environ-
ment (after rain) or in close vicinity with
working place should be well lit.
Further safety instructions for all opera-
tions
Kickback and Related Warnings
Kickback is a sudden reaction to a pinched or
snagged rotating wheel, backing pad, brush
or any other accessory. Pinching or snagging
causes rapid stalling of the rotating accessory
which in turn causes the uncontrolled power tool
to be forced in the direction opposite of the ac-
cessory's rotation at the point of the binding.
Kickback is the result of power tool misuse and/
or incorrect operating procedures or conditions
and can be avoided by taking proper precau-
tions as given below.
a)
and position your body and arm to al-
low you to resist kickback forces. Al-
ways use auxiliary handle, if provided,
for maximum control over kickback or
operator can control torque reactions or
kickback forces, if proper precautions are
-
b) Never place your hand near the rotating
accessory. Accessory may kickback over
c) Do not position your body in the area
where power tool will move if kickback
The
PMB 1200CE