Weelko WKB005 Manual De Instrucciones página 11

COLD HAMMER
Indicated after skin rejuvenation treatments, to
diminish the size of pores, to remove redness, to
decrease skin sensation and to improve skin's tone.
1. Plug the cable into the "Cold" side socket. Place it
so that "Open" remains on the upper part of the cable.
2. Clean the patient's face before treatment and apply
some gel on the area to be treated.
3. Press the "Cold" button on the screen.
4. Place the hammer on the patient's areas to be
treated.
RADIOFREQUENCY
1. Plug the cable into the "RF" side socket. Place it so
that "Open" remains on the upper part of the cable.
2. Clean the patient's face before treatment and apply
some gel on the area to be treated.
3. Select treatment time, adjust intensity from 1 to 10
with the arrows and select the type of wave using the
"MODE" buttons: continuous wave (left button) and
pulsed wave (right button). It is recommended to use
the first one for treatments on normal skins and
thicker tissues. The second one, however, is ideal for
sensitive skins and soft tissues. It is recommended to
start with the continuous wave and to gradually
increase the intensity.
4. Press the "RF" button on the screen to start the
treatment.
5. Move the handle by gently pressing the skin from
bottom to top or make small circles on the entire
surface of the face.
6. The operation should not last more than 10-15
minutes.
SPRAY
1. Plug the cable into the "Spray" side socket. Place it
so that "Open" remains on the upper part of the cable.
2. Clean the patient's face before treatment.
3. Fill the lotion to spray into the small plastic
container which is adapted to the spray pipe .
4. Press the "Spray" button on the screen.
5. Point the pipe towards the area to treat and start
spraying the lotion.
6. If at some point the nozzle is blocked up, clean away
any accumulated waste using a needle or a small tool.
PEELING ULTRASÓNICO
Eliminates dead skin cells, removes the excess of
cuticles and improves skin texture.
MODE A: Scrubber
1. Plug the cable into the "Scrubber" side socket.
Place it so that "Open" remains on the upper part of
the cable.
2. Clean and dry well the patient's face before
treatment. Apply some exfoliating product on the area
to be treated.
3. Select treatment time, adjust intensity from 1 to 10
with the arrows and select the type of wave using the
"MODE" buttons: continuous wave (left button) and
pulsed wave (right button). It is recommended to use
the first one for treatments on normal skins and
thicker tissue areas. The second one, however, is ideal
for sensitive skins and soft tissues. It is recommended
to start with the continuous wave and to gradually
increase the intensity.
4. Press and hold down simultaneously the two side
buttons of the scrubber probe and tilt it 45º as shown
on the image below.
5. Treatment time is around 15-20 minutes.
MODE A
MODE B: Galvanic
1. Plug the cable into the "Scrubber" side socket.
Place it so that "Open" remains on the upper part of
the cable.
2. Clean and dry well the patient's face before
treatment. Apply the proper lotion for the galvanic
function on the area to be treated.
3. Select treatment time, adjust intensity from 1 to 10
with the arrows and select the type of wave using the
"MODE" buttons: continuous wave (left button) and
pulsed wave (right button). It is recommended to start
with the continuous wave and to gradually increase
the intensity.
4. Press and hold down simultaneously the two side
buttons of the scrubber probe, press it firmly on the
skin and glide it smoothly over facial lines, as shown in
the picture above.
MODE B