Rinse Agent
To achieve proper drying, always use a liquid rinse agent,
even if your detergent
contains a rinse agent or drying
additive.
NOTE: The dishwasher
indicates low rinse agent by the
Rinse Agent Indicator
Light.
Add liquid rinse agent to the dispenser
until the rinse
agent reservoir is full.Wipe
up any excess rinse agent that
puddles when the dispenser reservoir is full.
After filling the rinse agent dispenser, the indicator light
will go out in a few minutes after the dishwasher
door is
shut.
Refer to the following page for more information
on adding
detergent and rinse agent to the dishwasher.
TO OPEN
....................
//
To open the cover, push the button as shown above.
Adding
Detergent
Adding
Rinse Agent
2 TBS(25 ML)
•
Use fresh powdered
detergent
for best results.
•
1 tablespoon
will clean most loads.
•
Do not use more than 3 tablespoons.
Do not overfill.
•
When using detergent
tabs, lay them fiat to
avoid
contact with the cover.
TO CLOSE
Lift tab to
open
•
Always use Rinse Agent even if your detergent
con-
tains rinse agent.
•
Add rinse agent when the Rinse Agent Indicator Light
on the control panel illuminates.
i
\
1 - Place finger as shown above
2- Slide door forward
and press down
firmly
until you
hear a click.
•
To add rinse agent, pour in the oval.
15