Electrical Connection; Instructions For Operation - Clatronic MS 3654 Instrucciones De Servicio

- in staff kitchens of shops, offices and other commercial areas.
It is not designed for use
- by visitors in hotels, motels and other residential facilities;
- on agricultural property;
- in bed and breakfast type environments.
Overview of the Components
1 Cover
2 Foam tank
3 Hot plate with safety switch
4 Motor/heating unit
5 Power cord
6 Reheat button with red LED
7 Cold button with blue LED
8 Stirrer for frothing milk
9 Stirrer for hot drinks without foaming
Preparation
• Remove the appliance and all included accessories from
the box.
• In order to remove any production residue, clean all acces-
sories before initial use as described in "Cleaning".
• Place the device on a stable, flat and dry surface.

Electrical Connection

• Check if the mains voltage to be applied matches the
voltage of the appliance. Refer to the rating label for
detailed specifications.
• The redundant length of the connecting cable can be
wound up at the bottom of the motor/heating unit. Connect
the power cord into a grounded outlet (If foam tank (2) is
not attached the LEDs in both buttons flash (6 and 7)).

Instructions for Operation

1. Open the lid (1): Pull the cover (1) upwards from the
foam tanks (2).
2. Insertion of a stirrer: At the bottom of the tank (2) you
see the axle of the stirrer (8 or 9). Insert the stirrer (8 or 9)
on the axle and check to make sure it can rotate freely.
3. Filling the foam tank (2): Fill the desired quantity of milk
or a hot drink in the foam tank (2). Note the corresponding
MIN and MAX markers in the foam tank (2) (lower MAX
marking for frothing milk, upper MAX marker for drinks
without foam).
32
MS3654_Instruction Manual_new
4. Function selection:
Function Button
Frothing cold milk
Frothing hot milk
Warm milk or
cocoa (without
foaming)
5. The selected button is lit continuously while the stirrer
(8 or 9) stirs drinks or foams. After about 2 minutes, the
device switches off automatically and the respective
button flashes about 8 times.
NOTE:
If the foam tank (2) has been lifted from the motor/heating
unit (4), the LEDs in the two buttons (6 and 7) blink.
Finish the operation and empty the foam tank (2)
• Turn off the illuminated button and unplug the power cord
(6).
• Wait until the stirrer (8 or 9) has come to a standstill.
• Remove the foam tank (2) from the motor/heating unit (4)
and pour the contents into a cup or into coffee.
• Clean all used components as described in Chapter
"Cleaning".
Recipes
Hot drinks:
Cappuccino
• Use the stirrer to foam (8) the milk for a cappuccino and
prepare hot frothed milk as described in the Chapter
"Instructions for Operation".
• Fill your cappuccino cup first with espresso and then add
milk foam and cold milk. We recommend a proportion of
1/3 espresso to 2/3 milk froth.
Latte Macchiato
• Use the stirrer to foam (8) the milk for a latte macchiato
and prepare hot frothed milk as described in the Chapter
"Instructions for Operation".
Stirrer
Stirrer (8) for
frothing
Stirrer (8) for
frothing
Stirrer (9) for hot
drinks without
foaming
01.07.16