Makita LS1216 Manual De Instrucciones página 23

Make sure that the pointers on the arm holder
point to 0° on the bevel scale plate on the
arm. If they do not point to 0°, loosen the
screws which secure the pointers and adjust
them so that they will point to 0°.
1
2
009490
(2) 45° bevel angle
1
2
3 4
009608
Adjust the 45° bevel angle only after
performing 0° bevel angle adjustment. To
adjust left 45° bevel angle, loosen the lever
and tilt the blade to the left fully. Make sure
that the pointer on the arm holder points to
45° on the bevel scale on the arm. If the
pointer does not point to 45°, turn the left 45°
bevel angle adjusting bolt on the side of the
arm until the pointer points to 45°.
To adjust right 45° bevel angle, perform the
same procedure described above.
Adjusting the position of laser line
For model LS1216L only
1
009526
1. Bevel scale
plate
2. Pointer
1. Pointer
2. Scale plate
3. Left 45 ﾟ bevel
angle adjusting
bolt
4. Right 45 ﾟ bevel
angle adjusting
bolt
1. Workpiece
2. Laser line
2
1
009527
WARNING:
As the tool is plugged when adjusting the position
•
of laser line, take a full caution especially at switch
action. Pulling the switch trigger accidentally cause
an accidental start of the tool and personal injury.
CAUTION:
Never look into the laser beam directly. Direct laser
•
beam causes damage to your eyes.
LASER RADIATION
•
Do not stare into beam.
Never apply a blow or impact to the tool. A blow or
•
impact causes the incorrect position of laser line,
damage to the laser beam emitting part or a short
life of the tool.
When adjusting the laser line appears on the left
side of the saw blade
1
1. Screw to change the movable range of the adjusting
screw
2. Adjusting screw
3. Hex wrench
4. Laser line
5. Saw blade
009514
23
1. Vertical vise
4
2
3
5