Sears Kenmore 116.22312 Manual Del Propietário página 15

1.Remove light
coverby pressing
in andliftingboth
sidesas shown.
Push In
And Turn
2. Push in and turn
bulb counterclock-
wise to remove,
3. Replace the bulb.
Bulb must not be
higher than 15 Watts
(130V)_ Close light
cover until it snaps in
place,
NOTE: See PARTS AND FEATURES for
Bulb #,
®
E
• CAUTION ......................
When you remove the end caps, a
small metal washer on each end
may come off, DO NOT lose these
two metal washers.
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficiency
high and to prevent damage to your vacuum,
the agitator must be cleaned every time the
belt is changed.
The agitator must also be cleaned according
to the following schedule:
Vacuum Use
Clean Agitator
HEAVY - every week
(used daily)
MODERATE - every month
(used 2-3 times/week)
LIGHT -
(used 1 timetweek)
every 2 months
Remove any dirt or debris in the belt path
area or in the brush roller area°
• Carefully remove
any string or
,, debris located on
the agitator, end
caps, washers or
agitator shaft.
iMPORTANT
Replace the washers and the end caps°
See the exploded view for' correct
assembly.
Disconnect cleaner from electrical outlet.
Check and remove hair, string and lint build-
up frequently in the Power-Mate ® agitator
and end cap areas, If build-up becomes
e,
excessive, disconnect Power-Mate from
wand and follow the steps below.
15