Starting The Machine - Zipper Maschinen ZI-RPE60C Manual De Instrucciones

 If the machine is working in an environment e.g. on soft or uneven ground, make sure to
reduce the horsepower to the lowest level to prevent the machine from sinking. On slopes
(max. 20° allowed!!!), make sure that the machine does not tilt.
 Pay particular attention to the following particularly dangerous areas:


Starting the Machine

ZIPPER MASCHINEN GmbH
ZI-RPE60C & ZI-RPE90C32
During tunnel work, good ventilation must be provided to prevent accidents. In
addition, the ventilation must be monitored.
www.Zipper-Maschinen.at
1. Fold up the handle and clamp the transport wheel in
the rubber holder.
2. Turn the fuel valve to the "O
3. Set the engine /
ON
the "On" position.
Note: The closed position of the choke lever enriches
the fuel mixture for starting a cold engine. The open
position provides the correct fuel mixture for normal
operation after starting and for restarting a warm
engine.
4. Turn the choke lever to the "Closed" position, only
for cold engine.
5. Set the throttle lever to "half throttle" (= middle
position between "fast" and "slow").
Note: Do not pull the starter rope through to the end
and do not let it rewind after pulling, but only rewind it
quickly.
6. Grab the starter handle and pull it out slowly. The
resistance becomes strongest at a certain point. This
point corresponds to the compression point. Let the
rope roll back a little from this point and then pull it
out powerfully.
7. Turn the choke lever to "Open when the engine is
running.
8. Open throttle further Machine starts compacting.
" position.
N
switch (ignition switch) also to
OFF
OPERATION
32