Tensioning The V-Belt; Changing The V-Belt; Cleaning The Spark Plug; Transport - Zipper Maschinen ZI-RPE60C Manual De Instrucciones

17.6.2 Tensioning the V-Belt

The V-belt is tensioned by moving the engine block on the vibratory plate.
1. Remove the V-Belt protection cover.
2. Loosen the four nuts securing the motor unit to the base plate until the motor can be
moved forward on the base plate.
Steps 3 and 4 only for ZI-RPE90C
3. Loosen the nut (M) to adjust the motor position with the screw (S).
a. Tighten the screw (S) (turn to the right) = tighten the belt.
b. Loosen the screw (S) (turn to the left) = Loosen the belt.
4. Once the belt has the correct tension, retighten the four nuts securing the motor unit to
the base plate and retighten the motor position adjustment screw using the nut (M).
5. Finally, retighten the V-belt protection cover.

17.6.3 Changing the V-belt

1. Loosen the V-belt and move it to the maximum foremost position.
2. Then pull over the V-belt over the pulleys.
3. Clean the drive wheels including the V-groove and the inside of the protective cover.
4. Install the new V-belt and tension the V-belt again.
5. Finally, reattach the V-belt protective cover.

Cleaning the spark plug

1. Pull out the spark plug cap and remove impurities from the outside of the spark plug.
2. Unscrew the spark plug using the spark plug wrench.
3. Check the ceramic insulation, clean the electrodes (metal tips) and check the distance
between the contacts. It should be 0.7 to 0.8 mm.
4. Reinstall the cleaned (or replaced) spark plug and replace the spark plug cap.
18

TRANSPORT

Never lift or transport the machine with the engine running!

Transport over shorter distances

For transport over short distances, use the hand holder and the mounted transport wheels:
ZIPPER MASCHINEN GmbH
ZI-RPE60C & ZI-RPE90C36
1. Release the transport wheels from the rubber holder and support the
wheel axle on the ground.
2. Pull the machine backwards until the base plate rests on the rubber
supports of the wheel suspension.
3. Press the handle vertically until the centre of gravity of
Move the machine only on level and firm ground.
www.Zipper-Maschinen.at
W A R N I N G
TRANSPORT
36