When The Work Is Done; Changing The Filter - Bosch BSG8 Serie Instrucciones De Uso

en

When the work is done

13
Figure
Switch the vacuum cleaner off and unplug
the power cord from the mains.
Tug the power cord and let go. The cable
then rewinds automatically.
To reactivate or deactivate the cable brake,
quickly tug the power cord.
On vacuum cleaners with an electronically
actuated cable rewind, the power cord
automatically rewinds when the machine is
unplugged at the socket.
If you do not want the power cord to
rewind completely (e.g. when changing the
plug), you can apply the cable brake by
pulling the power cord.
14
Figure
To store or transport the vacuum cleaner,
use the storage aid on the underside of the
vacuum cleaner. Stand the vacuum cleaner
up on its end.
Slide the plastic lug on the floor into the
groove on the underside of the unit.

Changing the filter

Replacing the MEGAfilt
dust bag
15
Figure
If the dust bag change indicator lights up
brightly and evenly when the floor tool is
lifted from the carpet and the highest
suction power is selected, the dust bag
must be changed, even though it may not
yet be full. In this case it is essential to
change the dust bag due to the type of
material it contains.
Turn the dust compartment locking lever in
the direction of the arrow to open the dust
compartment cover.
* Depending on equipment level
12
SuperTEX
®
16
Figure
Seal the MEGAfilt
pulling the sealing strip and then remove it.
17
Figure
Insert a new MEGAfilt
into the holder and close the dust bag
compartment lid.
Caution: The dust bag compartment
!
lid will only close when the
MEGAfilt SuperTEX dust bag or textile
®
filter are inserted.
If the dust bag change indicator is still
lit after the dust bag has been changed,
please check whether the nozzle, tube
or flexible hose are blocked.
Cleaning the motor protection filter
The motor protection filter should be cleaned
regularly by knocking out the dirt and rinsing.
18
Figure
Open the dust bag compartment lid
(see Figure 15).
Pull out the motor protection filter in the
direction of the arrow.
Clean the motor protection filter by
tapping it.
If it is very dirty, the motor protection filter
should be rinsed.
The filter must then be left to dry for at
least 24 hours.
After cleaning, insert the motor protection
filter into the appliance as far as it will go
and close the dust bag compartment lid.
SuperTEX dust bag by
®
SuperTEX dust bag
®