Fell Marine WiMea Boat Unit BU90115 Manual De Usuario página 4

Overview
Press and Hold to Pair
Pair any WiMEA MOB Unit to any WiMEA Boat Unit. Your Boat Unit
remembers the last 20 paired MOB Units. Family or friends can
have their own MOB Unit for the same boat with a WiMEA Boat
Unit installed. The MOB Unit connects to the latest paired Boat Unit
using ID technology.
One click – Connect / Disconnect System
After your MOB Unit and Boat Unit are paired for the first time,
click your MOB Unit once when entering the boat to start
driving. You are now free to move around safely. When
disembarking the boat – click the MOB Unit once more to
disconnect.
MOB situation and Direct Restart System
FELL WiMEA Protocol automatically triggers MOB Mode (Man
®
Overboard Mode) when the MOB Unit goes into the water or
travels out of range from the connected Boat Unit. 6 seconds after
stopping the engine the Override Mode is engaged and
automatically switches the signal relay to the engine back on.
This allows any passengers on board to quickly restart the engine
and pick up the missing driver in the water, without the need to
interact with the Boat Unit.
MOOR Mode System
In the event you as the driver need to exit the boat while mooring
or performing other tasks, you can engage MOOR Mode. Simply
Press & Hold your MOB Unit for 3 seconds while being connected.
WiMEA will be in standby for 2 minutes, allowing you to go out of
wireless range without the engine stopping. After 2 minutes the
system will automatically reconnect if you are within range of your
Boat Unit.
6
Pairing
After proper installation, pair the MOB Unit and the Boat Unit, as
described below:
Press and hold the button on your Boat Unit.
Release the button when the Boat Unit starts
flashing blue and gives a sound signal indicating
Pairing Mode.
Immediately after releasing the button on the
Boat Unit, press and hold the button on your
MOB Unit. Keep the MOB Unit within 1 meter
range from the Boat Unit.
The Boat Unit will give a sound signal and the
light will flash green to indicate that the units
was paired successfully. You can now release the
button on your MOB Unit.
7