MOB Mode overview
1.
The MOB Unit falls into the water or goes out
of range.
2.
Engine shut down.
3.
6 seconds engine shut down procedure is
activated - Indicated by flashing red light and
sounding an alarm.
4.
6 seconds after engine shut down, Override
Mode automatically engages – allowing
passengers or crew on board to start the engine
and pick up the missing person in the water.
5.
You can disconnect MOB Mode or Override
Mode by clicking the button on the MOB Unit.
6.
Reconnect after MOB/Override Mode by first
disconnecting, either by clicking on the Boat
Unit or the MOB Unit button. Then click again
on the MOB Unit to reconnect.
NOTICE
The Override Mode engaged after MOB Mode
will time out after 2 hours. This is to prevent the
system from staying activated in the event that
you leave the boat without disconnecting the
MOB Unit first.
12
Override Mode
Override Mode enables you to start the engine and drive your boat
in the event that you do not have your MOB Unit or your MOB Unit
is out of battery. You can engage Override Mode and start your
engine to drive without using the MOB Unit. The Boat Unit will
flash a yellow light every 5 seconds and sound a signal every 30
seconds when in Override Mode. This is to remind you that you are
not wirelessly connected with your MOB Unit and thereby not safe
in the event that you would fall overboard.
We encourage you to always use the MOB Unit when driving your
boat. Make sure that the battery is not depleted in your MOB Unit
before driving. Check the battery lights on your Boat Unit while the
MOB Unit is connected to verify the battery status of your MOB
Unit.
Engage Override Mode
Press and Hold the button of your Boat Unit
for at least 10 seconds.
First you will notice the blue light flashing
and the sound signal as if you were entering
Pairing Mode on your Boat Unit.
13