Overload Cutout; Storing The Machine; Replacing Nylon Line - Stihl FSE Serie Manual De Instrucciones

English

Overload Cutout

STIHL FSE 71 and FSE 81 electric
trimmers are equipped with an overload
cutout.
The overload cut out cuts off the power
supply in case of mechanical or thermal
overload.
If the overload cutout has cut off the
power supply:
N
Wait about 3 minutes before
switching on again.
Do not switch on the unit during this
period because you will otherwise
prolong the required cooling time.
Once the motor starts:
N
Run the unit for about 15 seconds
off load. This helps cool the motor
windings and considerably delays
renewed tripping of the overload
cutout.
42

Storing the Machine

For periods of 3 months or longer
N
Thoroughly clean the machine,
especially the cooling air inlets.
N
Take out the spool with nylon lines
and engage the ends of the lines in
the spool's notches. Clean and
inspect the spool.
The resilience and service life of the
nylon line can be increased by storing it
in a container filled with water.
N
Store the machine in a dry, high or
locked location, out of the reach of
children and other unauthorized
persons.

Replacing Nylon Line

STIHL AutoCut C 5-2
Always check the mowing head for signs
of wear before replacing the nylon line.
If there are signs of serious wear,
replace the complete mowing
head.
Preparations
N
Stop the engine
N
Put the machine on the ground with
the mowing head facing up.
Disassembling the mowing head and
removing remaining nylon line
In normal operation, the supply of nylon
line in the head is used up almost
completely.
FSE 60, FSE 71, FSE 81