Unpacking - imaport Siena SN270BT Manual De Instrucciones

UNPACKING

The metal bandsaw is shipped from the factory in a
carefully packed crate If you find the machine to be
damaged, save the containers and all packing materials
call your agent
This metal bandsaw is a very heavy machine
(300 kgs shipping weight). DO NOT over
exert yourself while unpacking or moving
your machine--get assistance
that your machine must be moved up or
down a flight of stairs
stairs are capable of supporting the
combined weight of people and the machine
Serious personal injury may occur
When you are completely satisfied with the condition
of your shipment you should inventory its parts
Piece inventory
Main saw unit
4- Hex head screw M10x25
4- Spring washer 10mm
4- Washer 10mm
Bar stop/work stop
3 & 6 mm allen wrench
Machine stand parts
Right side panel
Left side panel
Rear panel
Front panel
21-Hex head screw M6x12
21-Washer 6mm
21-Hex nut M6
12-Hex head screw M8x20
12-Hex nut M8
24-Washer 8mm
Clean Up
The unpainted surfaces are coated with a waxy oil to
protect them from corrosion during shipment
protective coating with a solvent cleaner or citrus based
degreaser Avoid chlorine--based solvents as they may
damage painted surfaces should they come in contact
Always follow the usage instructions on the product you
choose for clean up
Many of the solvents commonly used to clean machinery
can be highly flammable
ingested Always work in well--ventilated areas far from
potential ignition sources when dealing with solvents
care when disposing of waste rags and towels to be sure
they do not create fire or environmental hazards
children and animals safely away when cleaning and
assembling this machine
Do not use gasoline or other petroleum-based solvents to
remove this protective coating
have low flash points which makes them extremely
flammable A risk of explosion and burning exists if these
products are used Serious personal injury may occur
In the event
be sure that the
Remove this
and toxic when inhaled or
Keep
These products generally
All die cut metal parts have a sharp edge (called "flashing"
) on them after they are formed
at the factory
inspection
lacerations when handled, please examine the edges of all
die-cut metal parts and file or sand the edge to remove the
flashing before handling
Use
This is generally removed
Sometimes a bit of flashing might escape
and the sharp edge may cause cuts or