Mitre Cutting - imaport Siena SN270BT Manual De Instrucciones

CUTTING CAPACITY in mm.
Angle
0° 170
30° 150
45° 130
60° 70

MITRE CUTTING

It is possible to perform mitre cutting (max.60°).
To perform this operation, simple loosen the vice lock lever
positioned on the machine base and rotate the head
to the angle required; finally tighten the above mentioned lock
lever.
This operation must be performed with the machine off
and voltage disconnected.
The lock lever must be tightened securely to avoid any
movement of the head during cutting.
170 210X170
140
110
60
DANGER!
VICE UNIT
The vice unit is equipped with a quick lock system with a
shifting is approx.4 mm. Use the handwheel to brin g
the jaws to approx. 2 mm from the piece to be cut and then
clamp the piece by means of the quick lock lever
WARNING!
Before executing the cut, ensure that the workpiece is
firmly secured in the vice to prevent it from moving
during the cutting operation.
WARNING!
Do not position the pieces to be cut on the vice unit while
a workpiece is already inserted in the vice.
DANGER!
THE OPERATION MUST BE CARRIED OUT WITH THE
MACHINE HEAD IN THE STANDBY POSITION AND THE
SAW BAND STOPPED.
CUT OFF THE POWER SUPPLY TO THE MACHINE.