CAMPAGNOLO ERGOPOWER POWER-SHIFT Manual De Instrucciones página 18

2.2.2 - Rear brake cable and casing
• Fit the brake cable (1,600 mm long
- diameter ø 1.6 mm) in the bushing
on the Ergopower control brake lever,
™
making sure that the cable stop head
fits into its seat (Fig. 28).
• Ergopower Power-Shift control
™
levers do not require a brake casing
end.
• Depending on your frame, it may be
necessary to cut the rear brake casing
(1,250 mm long - diameter ø 4,9 mm)
and install a casing lead end (diameter ø
6 mm, not supplied in your Ergopower
™
control levers package).
• Fit the casing (without the casing end) in the brake casing retainer and secure
the cable to the brake (refer to the brake instruction manual for proper attach-
ment of the cable to the brake).
2.2.3 - Front brake cable and casing
• Fit the brake cable (800 mm long - diameter ø 1.6 mm) in the bushing on the
Ergopower control brake lever, making sure that the cable stop head fits into
™
its seat (Fig. 28).
• Ergopower Power-Shift control levers do not require a brake casing end.
™
• Fit the casing (580 mm long - diameter ø 4,9 mm) in the brake casing retainer
(without the casing end) and secure the cable to the brake (refer to the brake
instruction manual for proper attachment of the cable to the brake).
28
34
2.3 - Taping the handlebar
• Raise the support cover Figure
29.
• Tape the handlebar (Fig.29) of the
Ergopower control body.
™
WARNING!
Malfunctioning of the
Ergopower control could cause
TM
accidents, physical injuries or
death.
• Refit the support cover in posi-
tion.
WARNING!
Before using your Ergopower system or public roads, ride in an open,
™
traffic free area to become familiar with the Ergopower's function and
operation. Failure to do so could result in an accident, personal injury
or death.
35
29