MRA 10635 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
4 Plastic washers 12x5x0.5mm
2 Distance sleeves 15mm
2 Distance sleeves 3mm
2 Fillister head screws, M5x30mm
2 Fillister head screws, M5x20mm
4 O-rings, 4.5x1.5mm
1 Edge protection strip with clamping
sleeves
Fitting the windscreen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Disassemble the original fairing screen.
3. Take the MRA windscreen and insert the 5X30mm fillister head screws [10566] with the
plastic washers [10635] through the upper holes of the screen. Now, place the 15mm
distance pieces against these from behind and secure them with the O-rings supplied
[10992], (P1).
4. Use M5x20mm fillister head screws [10673] with plastic washers [10635] for the lower
holes. Now insert the 3mm distance sleeves [10872] from the inside and secure these
using the O-rings [10992]
5. In the next step, mount the MRA windscreen to the motorcycle and tighten the screws.
6. Mount the edge protection strip as shown in picture 1. Push the clamping sleeves over
the ends of the protective edge strip and lightly compress them, using a pair of pliers to
secure the protective edge strip profile.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
CRF1100L /DCT 2020-
Article No..
--- Allen key 3 and 5mm
10635
10636
10872
10566
10673
10992
---
3
Required tools