Assembly - Delta 22-790X Manual De Instrucciones

1. Open end wrench (10 and 12 mm)
2. Open end wrench (14 and 17 mm)
3. Hex wrench (6 mm)
4. Hex wrench (4 mm)
For your own safety, do not connect the machine to the power source until the machine is completely
assembled and you read and understand the entire instruction manual.
HOW TO ASSEMBLE STAND
1. Attach the side panels (A) Fig. 1 to the legs (B). For
each side panel, use (4) M8 hex head bolts and M8 lock
washers at (C) as shown in Fig. 1. Tighten with 14 mm
wrench (provided).
2. Attach side panels (A) Fig. 2 to the end panels (D).
NOTE: Be sure hole (E) Fig. 2 is up and end panel is
oriented as shown in Fig. 2.
To assemble, place M8 carriage head bolt through end
panel and then through the side panel at (F). Place
an M8 lock washer and M8 hex nut onto end of M8
carriage head bolt and tighten in place. Repeat for all
four holes in each end panel.
3. Attach the top brackets (G) to both side panels (A) at
four holes (two of which shown at (H) Fig. 3). Place M8
carriage head bolts down through top bracket and then
the side panel. Place M8 lock washers and then M8 hex
nuts onto carriage head bolts and tighten.
4. Attach leg support (I) and clips (J) to end panels as
shown in Fig. 4. Insert two M6 hex head bolts through
clips, then leg support and then end panel. Place M6
lock washer then M6 hex nut on M6 hex head bolt and
tighten with 10 mm wrench (provided).
G

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
- provided
- provided
- provided
- provided
ASSEMBLY TIME ESTIMATE
Assembly for this machine takes approximately 1 hour.
A
H
Fig. 3
5. Hex wrench (3 mm)
6. Hex wrench (2.5 mm)
7. 10, 12, 14, 17 mm Sockets - not provided
2 x 4's
8. 2 -
E
D
Fig. 2
Fig. 4
8
- provided
- provided
- not provided
A
B
C
F
I
Fig. 1
A
J