Problem Solving - Miele SEB 228 Instrucciones De Manejo

en
Releasing the connection
socket
 Press the foot switch for releasing the
connection socket (see "Guide to the
appliance") and release it.

Problem solving

The Electrobrush switches itself off.
The overheating protection mechanism
has been activated due to overheating
or a blockage.
 Disconnect the vacuum cleaner from
the electrical supply immediately.
Switch off at the wall socket and un-
plug it.
 Check the vacuum cleaner for any
blockages and check all the filters in
the vacuum cleaner.
The Electrobrush has to cool down. To
speed this up:
 Switch the vacuum cleaner back on.
The Electrobrush will be ready for use
again after about ten minutes.
Maintenance and care (dia. 5)
Removing threads and hairs
 Always disconnect the vacuum
cleaner from the electrical supply for
maintenance work and for cleaning.
Switch off at the wall socket and un-
plug it.
 Use scissors to cut any threads or
hairs which have wound around the
roller brush. There is a groove on the
roller to guide you.
Then run the vacuum cleaner to va-
cuum up the bits.
12