Clatronic BS 1294 N Instrucciones De Servicio página 32

NOTE:
If the red mark is visible, pull in the cable with the help of
the cable winding button back to the yellow mark.
2. Insert the mains plug into a correctly installed power socket.
3. Turn the device on by the on/off switch by pressing down
the button.
4. Set the "carpet/hard floor" switch, depending on the floor
covering.
5. Vacuum at a steady speed. There is no need to exert pres-
sure.
NOTE:
Pay attention to the range that can be covered with the
cable length!
Air Slide (15)
Open the air slide on the hose handle in order to regulate the
airflow or to clear any particles sticking to the nozzle.
Switching off and Winding up the Mains Lead
1. Turn the vacuum cleaner off by the on/off switch and
remove the plug from the socket.
2. Keep the plug in your hand.
3. Press the cable winding button and guide the cable. Hold
the cable to avoid wrapping.
Maintenance
Emptying the Dust Collector
Empty the dust collector once the collected dirt reaches the
MAX marking.
1. Disconnect the mains plug from the wall socket.
2. Press the button (10) to
release the dust collector.
Remove the dust collector.
3. Empty the dust collector
over a dustbin. In order to
do so, press the button on
the dust collector to open
the base plate.
4. Then close the base plate again.
5. Attach the dust collector to the appliance. It must engage
with a click.
32
Filter
Your appliance features 4 filters. The common dust bag system
has been replaced by a transparent dust collector. The higher
flow speed of the collector allows for heavy dirt and smallest
floating particles to be separated from the "sucked-in air".
It is thus not necessary to buy dust bags.
HEPA Filter
Clean the filter element twice a year.
CAUTION:
• Never wash the filter in the washing machine.
• Do not use a hairdryer for drying.
• Only use the appliance after the filters have been
installed correctly.
Proceed as follows to remove, clean and reinstall the filter ele-
ment:
1. Empty the dust collector as described previously.
2. Remove the dust collector lid. To do so, turn the ↓ marking
on the lid towards the symbol. Pull the filter element from
the dust collector.
3. Remove the filter element from the lid by turning the filter
element towards OPEN.
4. Pull the nylon filter from the HEPA.
5. Use a brush to clean the
filters. In case of heavy
staining, clean the filters
under running water.
6. Let the filters air-dry
completely before refitting
them!
7. Wipe the dust collector with a damp cloth and then wipe it
dry.
8. Once the filters are com-
pletely dry, attach the nylon
filter to the HEPA filter.
9. Reinsert the filter element
into the lid of the dust
collector, using the notches
in the lid. Turn the filter ele-
ment towards the CLOSE
symbol.
10. Reinsert the lid including the filter element into the dust
collector. Close the lid until the ↓ marking is aligned with
the symbol.
11. Fit the dust collector in the appliance.