RedMax SGCZ2401S Manual De Instrucciones página 30

OP5
.04 in
(1~2mm)
OP6
30
(1)
(1)
English
8. Operation
■ STOPPING ENGINE (OP3)
1. Release the throttle lever and run the engine for a
half minute.
2. Shift the ignition switch to the STOP position.
IMPORTANT
• Except for an emergency, avoid stopping the engine
while pulling the throttle lever.
■ ADJUSTING THROTTLE CABLE
• The normal play is 1 or 2mm when measured at the
carburetor side end. Readjust with the cable adjuster
as required. (OP5)
(1) cable adjuster
■ ADJUSTING IDLING SPEED (OP6)
1. When the engine tends stop frequently at idling
mode, turn the adjusting screw clockwise.
2. When the cutting head keeps rotating after releasing
the trigger, turn the adjusting screw counter-
clockwise.
(1) idle adjusting screw
NOTE
• Warm up the engine before adjusting the idling
speed.
■ USAGE
This machine does cutting not by a rotary cutter like
conventional trimmers but by a pair of special blades,
each upper blade and lower blade oscillate opposite
direction alternately within a limited angle at a speed of
approximately 1/30 of conventional trimmers.
This unique mechanism brings you many benefits like
the following:
1. Since the blade does not cause grass chips and
pebbles to the thrown around, you may use less
care about your clothing or surroundings.
2. Should the blade hit a rigid object like stones, trees
or steel poles during operation, it does not produce a
bounce motion that can cause loss of machine
control.
3. Since the blade does not cause cut grass to wrap
around the neck, you need not to stop operation to
remove such wrappers.