Additional Safety Rules For Electric Planers - SPARKY P 282 Instrucciones De Uso

This will ensure that the safety of the power
tool is maintained.
Additional safety rules
for electric planers
An exposed rotating cutter may engage the
surface leading to possible loss of control and serious
injury.
Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
Holding the work by your hand or against the body
leaves it unstable and may lead to loss of control.
mask.
overheating.
sure that it has the right ampere rating for your power
tool and is in safe electrical condition.
accessories could be hot.
reasonable speed. Overloading will occur if too much
pressure is applied and the motor slows resulting in
inefficient planing and possible damage to the planer
motor.
left around the work area.
workpiece. You can damage the blade and the tool
by cutting into a nail or other foreign object. It can also
present a safety hazard.
tightened before operation.
on and let it run for a while. Watch for vibration or wob-
bling that could indicate poor installation or a poorly
balanced blade.
piece when you switch the machine on.
and body.
to a complete standstill before attempting any adjust-
Original instructions
ments
may jam in the chute when cutting damp wood. Clean
out the chips with a stick but only when the tool has
been turned off and unplugged from the power point.
ate the tool only when controlled by both hands.
front base up on a wooden block so that the blades
are not in contact with anything.
wise the resulting imbalance will cause vibration and
shorten the blade and tool life.
WARNING: Before connecting a tool to a
tool can result in serious injury to the user, as well as
damage to the tool.
source with a voltage less than the nameplate rating
is harmful to the motor.
Any use other than those mentioned in this Manual
will be considered a case of misuse. The user and not
the manufacturer shall be liable for any damage or in-
-
jury resulting from such cases of misuse.
regulations, the assembly instructions and the oper-
ating instructions to be found in this Manual. All per-
sons who use and service the machine have to be
acquainted with this Manual and must be informed
about its potential hazards. Children and frail people
must not use this tool. Children should be supervised
at all times if they are in the area in which the tool is
being used. It is also imperative that you observe the
accident prevention regulations in force in your area.
The same applies for general rules of occupational
health and safety.
made to the tool nor for any damage resulting from
such changes.
Even when the tool is used as prescribed it is not pos-
sible to eliminate all residual risk factors. The following
hazards may arise in connection with the tool's construc-
tion and design:
not worn.
making any adjustments or maintenance, including
changing the blades and adjusting the depth of cut.
-
making contact with the blade.
-
-
5
EN