Adjusting Depth Of Cut; Bevel Cutting; Switch Action; Electric Brake - Makita BSS610 Manual De Instrucciones

Sierra sin cordon
Ocultar thumbs Ver también para BSS610:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

cannot be seen. If not, it may accidentally fall out of
the tool, causing injury to you or someone around
you.
Do not use force when inserting the battery
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.

Adjusting depth of cut

1
CAUTION:
After adjusting the depth of cut, always tighten the
lever securely.
Loosen the lever on the side of the rear handle and move
the base up or down. At the desired depth of cut, secure
the base by tightening the lever.
For cleaner, safer cuts, set cut depth so that no more
than one blade tooth projects below workpiece. Using
proper cut depth helps to reduce potential for dangerous
KICKBACKS which can cause personal injury.

Bevel cutting

1
0-45
0-50
1
Loosen the lever on the bebel scale plate on the front
base. Set for the desired angle (0° - 50°) by tilting accord-
ingly, then tighten the lever securely. Use the 45° stopper
when you do precise 45° angle cutting. Turn the stopper
counterclockwise fully for bevel cut (0° - 45°) and turn it
clockwise for 0° - 50° bevel cuts.
006701
1. Lever
006702
1. Lever
006703
1. Stopper
Sighting
B
For straight cuts, align the A position on the front of the
base with your cutting line. For 45° bevel cuts, align the B
position with it.

Switch action

1
CAUTION:
Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
Do not pull the switch trigger hard without pressing
the lock-off lever. This can cause switch breakage.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided. To start the tool, press
the lock-off lever and pull the switch trigger. Release the
switch trigger to stop.
WARNING:
For your safety, this tool is equipped with lock-off
lever which prevents the tool from unintended
starting. NEVER use the tool if it runs when you
simply pull the switch trigger without pressing the
lock-off lever. Return tool a MAKITA service center
for proper repairs BAFORE further usage.
NEVER tape down or defeat purpose and function
of lock-off lever.

Electric brake

This tool is equipped with an electric blade brake. If the
tool consistently fails to quickly stop blade after switch
trigger release, have tool serviced at a Makita service
center.
The blade brake system is not a substitute for lower
guard. NEVER USE TOOL WITHOUT A FUNCTIONING
LOWER GUARD. SERIOUS PERSONAL INJURY CAN
RESULT.
7
006704
1. Base
2. Cutting line
1
2
A
006705
1. Switch trigger
2
2. Lock-off lever

Publicidad

Tabla de contenido
loading

Tabla de contenido