Publicidad
Idiomas disponibles
Idiomas disponibles
2 - ENGLISH
SM1000-2P & SM1000-2PF ENDURO™ ELITE SERVO MOTOR
WITH POSITIONER USER INSTRUCTIONS
Congratulations!
You have purchased the Enduro
savings compared to clutch motors. With the high and rising cost of electricity, you just can't afford to
run a clutch motor any longer. The power and dependability of the brushless Enduro
exceptional. This workhorse just won't quit.
Please read these instructions carefully before installation, operation or maintenance.
General Introduction
The Enduro™ Elite SM1000 Servo Motor is designed to meet almost all basic heavy duty and
continuous use requirements of various industrial sewing machines. It utilizes extremely powerful
rare-earth Neodymium permanent magnets. The motor produces almost no noise, saves energy and
is brushless, speed adjustable and durable. It provides a high starting torque even at low speed or
from a complete stop.
By using a modern technologically advanced microprocessor, Hall sensor and Pulse-Width Modulation
technology, the Enduro™ Elite SM1000 can be set to rotate at different maximum speeds, in either normal
or reverse directions, and can start with different accelerating speeds. It will stop automatically with any
interruption such as in-line voltage, electrical surge, radio frequency interference or overloading. It is
fully protected by the software and will give error messages indicating which problem is encountered. It
even works well in environments with an unstable electrical power supply.
The positioner motor comes with a positioner sensor kit included. With correct installation and settings,
Enduro
™
Elite SM1000-2P can provide accurate Needle Positioning of either the UP or DOWN position
every time. In addition to Needle Positioning, Enduro
sends a 24VDC signal for activating a solenoid for lifting the presser foot on the sewing machine.
CAUTION
1. Remove your foot from the pedal when turning the power ON.
2. Turn the power switch OFF before replacing or threading the needle.
3. Turn the power OFF when leaving the machine.
4. When performing maintenance on the sewing machine, turn the motor power switch to
the OFF position. Remove the power cord from the back of the motor to completely
disable all power to the sewing machine.
5. Always ground the grounding wire.
6. Always turn off the power switch before connecting or disconnecting each connector.
7. To avoid an accident, do not alter this motor and control box.
Warranty
This product is covered with a 1 year limited warranty. If the motor fails to perform its designed function
due to manufacturer's defects, contact the place you purchased it from for repair or replacement.
This warranty does not cover defects due to dropping, power surge, spikes or misuse.
™
Elite SM1000 motor that pays for itself with 60% to 80% energy
™
Elite SM1000-2PF provides Foot Lift output which
www.endurosaves.com
™
Elite SM1000 is
Publicidad
