Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Put the mounting bracket of the motor upwards to the bottom of the tabletop and fi x the motor to the
tabletop with the bolts provided. Connect the treadle rod with the connecting rod joint. Install the female
plug of the cable from the switch box into the power inlet socket in the back of the motor box.
Wiring
For 220 volt single phase motor follow the diagram below:
Note: When wiring the motor to the power source, connect both the black and white wires to
achieve 220 Volts (green to ground). If you are in an area (China / Europe) that supplies 220 Volts
from a single lead, then connect the power source to the black wire. The white wire will then be the
neutral and the green wire will be the ground.
Error Message and Trouble Shooting
E2: Motor Phase signal error.
E3: Motor protected against over-current.
E4: Circuit board error.
E5: Display module and control module communication error.
E6: Pedal position sensor error.
E8. Can not fi nd position DOWN.
E9. Can not fi nd position UP.
Setting Up
Turn on the switch located on the switchbox. The display will
show "POS.d" which means "needle position down", this means
the motor is now in "ready" status, ready to work or be set.
www.endurosaves.com
ENGLISH - 3
default "ready" status
Publicidad
