NuVinci N170S Manual Del Propietário página 7

Refitting .the .Rear .Wheel .
a . .
Put the chain on the freewheel; orient
the axle flats so the axle can enter the
dropouts; and place the wheel in the
dropouts.
b . .
Install the no-turn washers on each axle
end. Orientation of the no-turn washer tabs
is determined by chain length. Place the
tabs behind the axle only if there is not
sufficient room in front.
Improper installation of the
no-turn washer will result in damage
to the dropout and the hub.
c . .
Grease the o-ring and the adjacent
shoulder on the shift rod and thread the
shift rod into the drive side axle by rotating
it clockwise until it stops and the shift rod
shoulder is flush with the axle.
Only use your fingers to install,
and be careful not to bend or
damage the end of the shift rod.
d . .
Keeping the main shaft nut tight against
the shift rod retainer nut, screw the
shift rod retainer nut onto the drive side
axle and tighten with an 11mm socket
and torque wrench to 20Nm (15 ft. lbs.)
e . .
Screw the acorn nut onto the non drive
side axle, but do not tighten.
f . .
If applicable, attach the roller brake arm
to the bike frame clamp. Do not fully tighten
the bolt until the wheel is secured in the
frame; then tighten the bolt to the torque
specified by the brake manufacturer.
8
English
Owner's Manual - December 2008
© 2008 Fallbrook Technologies Inc.