Before Getting Started; Risk Of Electric Shock - Franklin Electric PUMPTEC-PLUS Guía De Instalación Y Funcionamiento

Before Getting Started

Read and follow safety instructions. Refer to product data plate(s) for additional
operating instructions and specifications.
This is the safety alert symbol. When you see this
look for one of the following signal words and be alert to the potential for personal injury:
DANGER
death or major property damage if ignored.
WARNING
injury, death or major property damage if ignored.
CAUTION
injury or major property damage if ignored.
NOTICE
related to hazards. Carefully read and follow all safety instructions in this manual
and on pump.
WARNING

RISK OF ELECTRIC SHOCK -

grounding type attachment plug. To reduce risk of electric shock, be certain that it is
connected only to a properly grounded, grounding-type receptacle. Disconnect power before
working on or around the Inline system. Do not use the Inline system in swimming areas.
This equipment should be installed by technically qualified personnel. Failure to install
it in compliance with national and local electrical codes and within Franklin Electric
recommendations may result in electrical shock or fire hazard, unsatisfactory performance
or equipment failure. Installation information is available through pump manufacturers and
distributors, or directly from Franklin Electric at our toll-free number 1-800-348-2420.
This equipment must not be used by children or persons with reduced physical, sensory or
mental abilities, or lacking in experience and expertise, unless supervised or instructed.
Children may not use the equipment, nor may they play with the equipment or in the
immediate vicinity.
If the power cord is damaged, it must only be replaced by qualified personnel.
CAUTION
• Keep work area clean, well-lit, and uncluttered.
• Keep safety labels clean and in good condition.
• Wear safety glasses while installing or performing maintenance on pump.
• Do not run pump dry. Fill pump with water before starting or pump will be damaged.
• Make sure all ELECTRICAL POWER IS OFF before connecting any electrical wires. Wire
Inline Pressure Boosting System for correct voltage. Follow all pump wiring instructions
provided in the "Wiring" section of this manual.
warns about hazards that will cause serious personal injury,
warns about hazards that can cause serious personal
warns about hazards that will or can cause minor personal
indicates special instructions which are imported but not
This pump is supplied with a grounding conductor and
symbol on your pump or in this manual,