Whispbar Fitting Kit Instrucciones De Montaje página 9

EN
Fitting Kit
K508W
Use two M5 x 12 mm self tapping screws to
secure the assembly onto the leg.
Do not over tighten.
Fitment
Apply protective strip as shown.
Trim if required.
Locate two holes at each position along the
inside of the roof rails.
Ensure the two pins of the clamp engages
correctly with the holes in the roof rail.
Place crossbars approximately above
these holes on roof rails.
Place one hand on the leg and apply
downward pressure.
Slide clamp through opening in leg.
9