tefen MixRite Manual Del Usuario página 5

Installing the MixRite on a Bypass line (off line)
Where water is supplied at a higher flow rate, than the working
flow rate of the injector or where the injector isn't needed for
continuous operation, the MixRite must be installed on bypass line.
The bypass provides the possibility to close the operation of the
injector while water continues to flow through the line.
1. Install onto the water line using swivel connectors and ensure
that the water flows into the MixRite in the direction indicated by
the arrows printed on the MixRite.
2. Install a 50-75 mesh (250-300 micron) filter between the valve
and the injector intake.
3. Valves have to be installed at the bypass entry and exit and on
the main water line.
4. Position the liquid additive container beneath the injector. Check
to ensure that the suction pipe is not bent or folded. Position the
drawing pipe into the additive container. Ensure that the suction
pipe filter is set several millimeters above the container's bottom.
Install the MixRite on Bypass Line (Off Line)
5