Test Operation - American Standard Advanced Clean 100 SpaLet Manual De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

[Note 7-1]
● Ensure to install the batteries in the correct
direction (note the negative and positive).
● Do not mix old and new batteries.
● Use the supplied batteries.
8

Test Operation

(Follow the steps below to conduct a test operation when installation is completed.)
●Is there any water leakage?
[See Note 8-1]
1. Open the water shutoff valve.
Checked
Leakage
check
● D o the rear washing and front washing operate properly?
[See Note 8-2]
1. Connect the power plug to the outlet.
2. Roll up the sleeve and place the arm so that the palm is
over the center of the SpaLet bowl.
Check
Checked
item
Rear
washing
nozzle
Bidet
nozzle
3. Remove the arm from the SpaLet bowl.
[Note 8-1]
● Water leakage at the supply/drain water
connecting sections may not be observed
unless the SpaLet is flushed several times.
Is there any leak?
* Flush the SpaLet several times.
(Water leakage at the supply/drain water connecting
sections may not be observed unless the SpaLet is
flushed several times.)
① Between the water shutoff valve and the water supply
hose
② Between this product and the water supply hose
③ Between this product and the SpaLet bowl
④ Between the SpaLet bowl and the floor
1. Does the warm water with an appropriate
temperature come out from the nozzle?
① Press the [CLEANSING] button.
② Ensure that the shower comes out from the nozzle to the palm.
2. Does the shower stop when the [STOP] button is pressed?
1. Does the warm water with an appropriate
temperature come out from the nozzle?
① Press the [BIDET] button.
② Ensure that the shower comes out from the nozzle to the palm.
2. Does the shower stop when the [STOP] button is pressed?
[Note 7-2]
● Ensure that there is enough space above the
remote control installation position to allow
easy removal and mount of
the remote control (see the
figure below).
Details
Details
[Note 8-2]
● This product is equipped with a seat sensor that detects
the user. In order for the rear washing and front washing
features to operate, the user must be seated.
-13 EN-
Remote control space
240 mm (9-7/16")
45 mm
(1-3/4")
CLEANSING
BIDET

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

8017a60grc

Tabla de contenido