American Standard Advanced Clean 100 SpaLet Manual De Instalación página 15

(1) Close the water shutoff valve to stop the water supply.
[See Note 10-1]
(2) Press the [FLUSH/FULL] button or press the flush button
on the SpaLet body.
* Wait approximately 20 seconds.
* Drain the water and remove the water pressure inside the
toilet body.
(3) Remove the side cover on the left (when facing the SpaLet
body).
(4) Rotate and remove the strainer on the lower left when
facing to the SpaLet.
* A small amount of water may spill out when removing the
strainer, so place a piece of cloth or similar on the floor.
(5) Wash away all debris inside the strainer and from the
O-ring.
(6) Fully tighten the strainer.
[See Note 10-2]
(7) Attach the side cover.
(8) Connect the power plug to the outlet.
(9) Open the water shutoff valve.
(10) Check for leaks from the water shutoff valve.
[Note 10-1]
● Do not remove the strainer when the water
supply valve is open.
* Water will leak from the strainer.
[Note 10-2]
● When installing the strainer, make sure that the
water shutoff valve is tightened completely.
* If this is not tightened completely, then there may be
water leakage from the strainer.
If the water does not flow well, clean the strainer.
shutoff valve
Side cover
[Note 10-3]
● How to drain the water from the SpaLet body
* Press both the [POWER SAVE ON/OFF] button
and [AUTO CLEAN] button on the remote control
at the same time for more than 2 seconds.
-15 EN-
Water
Open/close
knob
②
Strainer
①
Strainer
O-ring
Close