Maintenance - SPARKY MBS 1100 Instrucciones De Uso

5. Pull up the trigger and allow the belt to reach full
speed before moving it across the work.
6. Press the lock-on button if you require continuous
operation.
7. Bring down the sander onto the work piece and ap-
ply light pressure. (Fig. 7)
8. Sand with the grain, in parallel overlapping strokes.
9. To remove paint or smooth very rough wood, sand
across the grain at 45º in both directions, and then
10. Use the front roller only to sand corners or irregular
shapes.
11. Lift the sander off the work before switching off.
12. Remember to keep your hands away from the mov-
ing belt, as it will continue to move for a short time
after the machine is switched off.
13. Wear safety goggles, a dust mask and earmuffs.
1. Disconnect the plug from the power supply.
the dust extraction port (10). (Fig. 8)
plug from the power supply.
WARNING:
ty the dust bag when it is no more than half full. Do not
use the dust bag when sanding metal. The hot metal
particles could cause residual wood dust or the bag
itself to catch fire.
Dismount and empty the dust bag,
tapping it gently to remove dust. On occasion, slip the
bag off of the frame and turn bag inside out. Brush dust
off of the lining using a soft brush.
4. A vacuum cleaner adapter can be used to connect
a household vacuum cleaner or workshop dust ex-
traction system to the sander.
(Fig. 9)
This machine can be mounted to a bench for stationary
use.
by the inscriptions. Never mount the machine onto the
bench without the rubber pad.
rubber pad. The mounting holes (3) shall face towards
the operator.
mounting holes (3).
bench.
sure the clamps are tightened properly but do not over
tighten.
bench before switching the machine on.
The machine can be set to continuous operation by
means of the lock-on button.
Original instructions
pages-MBS 1100.indd 7
MBS 1100:
dust bag.
MBS 1100E:
set of 4 assorted sanding belts (60 grit - 2 pcs., 80 grit - 1
pc, 100 grit - 1 pc), thermoplastic elastollan (TPE) pad,
VII - Maintenance
WARNING: Always ensure that the tool is
switched off and unplugged before attempting to per-
form inspection or maintenance.
may vibrate loose over time.
Re-lubricate all moving parts at regular intervals.
When the carbon brushes are worn out, both brushes
must be replaced simultaneously with genuine brushes
at SPARKY service centre for warranty and post-war-
ranty service.
-
CLEANING
tilation slots clean. Regularly check to see if any dust or
foreign matter has entered the grills near the motor and
around the switches. Use a soft brush to remove any
accumulated dust. Wear safety glasses to protect your
eyes whilst cleaning.
If the body of the tool needs cleaning, wipe it with a soft
damp cloth. A mild detergent can be used.
WARNING: Never use alcohol, petrol or other
cleaning agent. Never use caustic agents to clean
plastic parts.
WARNING: Water must never come into con-
tact with the tool.
To assure product safety and reliability,
repairs, maintenance and adjustment (including brush
inspection and replacement) should be performed by
ganisations, always using genuine replacement parts.
-
-
7
EN
23.7.2012 г. 15:07:35 ч.