Remote Control; Using The Remote Control; Display - Pioneer A-A6-J Manual De Instrucciones

Controls and displays

Remote control

1
2
VOL
3
MUTE
TONE/BAL
INTEGRATED AMPLIFIER

1
Switches the amplifier between standby and
on.
2 VOL +/–
Use to set the listening volume.
3 MUTE
Mutes/unmutes the sound.
4 DIMMER
Dims or brightens the display (or switches the
backlight off).
5 Input selector buttons
Press to select an input source. These select
the component connected to the
corresponding input on the rear panel.
6 TONE/BAL controls
Use to adjust the tone and balance (page 12).
7 DIRECT
Press to access Direct listening (page 12).
DIMMER
4
TAPE
PHONO TUNER 5
AUX
6
L / R /
7
DIRECT

Using the remote control

Keep in mind the following when using the
remote control:
• Make sure that there are no obstacles
between the remote and the remote sensor
on the unit.
• The remote has a range of about 7 m at an
angle of about 30º from the remote sensor.
• Remote operation may become unreliable
if strong sunlight or fluorescent light is
shining on the unit's remote sensor.
• Remote controllers for different devices
can interfere with each other. Avoid using
remotes for other equipment located close
to this unit.
• Replace the batteries when you notice a
fall off in the operating range of the remote.

Display

1
TREBLE TREBLE
BASS BASS
1 Tone control indicators
TREBLE – Lights when high-range tone
adjustment is applied.
BASS – Lights when low-range tone
adjustment is applied.
2 Master volume level
3 Character display
Displays various system information.
2
dB dB
3
03
11
En