Menu Level 3: Operating Mode; Menu Level 4: Default Setting - Waeco CoolAir RT880 Instrucciones De Instalación

CoolAir RT880, SP950T
7.3.4

Menu level 3: Operating mode

The unit always starts with a defined operating mode for room tempera-
ture. This parameter can be configured:
➤ Start configuration mode (chapter "Starting and ending configuration
mode" on page 48).
✓ The first digit of the display (fig. 0 5,page 8) shows the menu level
and the second and third show the parameter which can be set.
➤ Press the + button (fig. 0 6,page 8) twice to switch to menu level 3.
➤ Press the Operating Mode button (fig. 0 4,page 8) to change the
parameters.
✓ The digits in the display flash until the parameter you entered is
confirmed.
➤ Use the + and – buttons (fig. 0 6 and 7, page 8) to set the mode with
which the unit starts up:
Characteristic
figure
0
1
2
3
➤ Press the Operating Mode button (fig. 0 4,page 8) to confirm your
entry.
✓ The set value is saved and is then used when the unit is restarted.
✓ You are now in menu level 3 again and can use the + and – buttons to
switch between menu levels.
7.3.5

Menu level 4: Default setting

You can reset the parameters you set in configuration mode on menu
levels 1 to 3 to the default settings:
➤ Start configuration mode (chapter "Starting and ending configuration
mode" on page 48).
✓ The first digit of the display (fig. 0 5,page 8) shows the menu level
and the second and third show the parameter which can be set.
➤ Press the + button (fig. 0 6,page 8) three times to switch to menu
level 4.
✓ The digital display shows
EN
Operating mode
Automatic mode
Operating mode 1
Operating mode 2
Operating mode 3
.
--
Installation
51