Overview; Installation; Initial Operation - Metabo TS 36-18 LTX BL 254 Manual De Instrucciones Original

13
Guide the push stick at an angle of 20° ... 30°
against the saw table's surface.
If the push stick is not used, it has to be stored
with the machine.
Replace push stick if damaged.

5. Overview

See page 2.
1 Table extension
2 Table insert
3 Splitting wedge
4 Clamping lever for fastening the blade guard
5 Blade guard
6 Clamping lever for securing the mitre fence
7 Mitre fence
8 Rip fence
9 Clamping lever for table side extension
10 Clamping lever for securing the ripping fence
11 Knurled nut for fine setting of the parallel limit
stop
12 Table extension
13 Push stick
14 Push stick holder
15 On/off switch
16 Crank for adjusting cutting depth
17 Handwheel for adjusting the angle of
inclination
18 Clamping lever to lock the angle of inclination
19 Bevel limitation stop
20 Open end wrench
21 Mitre fence holder
22 Chip bag holder
23 Blade guard holder
24 Ripping fence holder
25 Foot/handle of the frame
26 Separating cyclone holder
27 Chip bag
28 Separating cyclone
29 Extractor connection piece
30 Adjustment screw (clamping of the ripping
fence)
31 Battery pack adapter (2 x 18 V)
32 Release button for removing the battery pack
adapter *
33 Battery pack release button *
34 Battery pack*
35 Capacity and signal indicator *
36 Capacity indicator button *
* depending on the features / model

6. Installation

Ensure firm footing and keep your
balance at all times.
Installation without machine stand:
1. Lift tool with two persons out of packaging.
2. Place saw down on stable table or work
bench.
3. Bolt saw firmly onto table or work bench.
Installation with machine stand:
1. Lift tool with two persons out of packaging.
2. Place tool on ground.
3. Lift tool by handles and set up on edge
4. Pull out handles (25), turn them and engage
them.
25
5. Fold out the two table legs. To do this, press
the red swivel lever (37) downwards (with your
foot or hand) and swing down the table legs.
6. Tilt the tool slightly to the rear and press down
both table legs. The red swivel levers (37)
must engage.
37
7. Fold out the upper two table legs. To do this,
push the red swivel lever (38) to the right and
swing the table legs downwards.
The red swivel levers must engage.
8. Hold the saw round the centre of the upper
frame. Pull up saw and set down. (Hold
adjustable base in position with foot to prevent
slipping of the saw during installation).
9. Compensate for floor irregularities with the
adjustable base (39).

7. Initial Operation

Note:
Rubber chips might fly around during initial
commissioning. This depends on the design and
is harmless.
7.1 Assembly
Adjust splitting wedge (if required)
Note:
The splitting wedge (3) has been correctly set at
the factory. Readjustment prior to initial operation
is only required should the splitting wedge have
become maladjusted in transit.
1. Raise saw blade fully.
2. Turn screw (40) anti-clockwise, lift table insert
(2) and remove.
38
40
3. Release locking lever (41) (turn anti-
clockwise!).
4. Pull the splitting wedge (3) out of the lower
transport position upwards as far as the stop.
ENGLISH en
39
2
17