Cleaning And Care - Miele SEB 216 Instrucciones De Manejo

G

Cleaning and care

Always disconnect the vacuum
cleaner from the electrical supply
for maintenance work and cleaning.
Switch off at the wall socket and
remove the plug.
Removing threads and hairs
(illustrations e, f and g)
^ Cut any threads or hairs that have
become entangled on the roller brush
with a pair of scissors. Then run the
vacuum cleaner to vacuum up the
bits.
For more obstinate tangles or
blockages inside the Electrobrush, the
cover can be opened.
^ Loosen the two locking screws on the
underside of the brush with a small
coin, and take off the roller cover.
The roller brush can now be taken out
of its supports and cleaned. The
compartment interior can also be
cleaned.
When re-fitting the roller brush
please note the following
(see illustration h)
There are notches on the supports.
With a new roller brush:
Fit the supports so that the single notch
points towards the roller cover, (see left
hand illustration). The bristles protrude
approx. 2 mm. This is important for the
brushing effect. When the bristles are
slightly worn out:
^ Fit the supports so that two notches
point towards the roller cover, (see
right hand illustration).
12
^ Put the roller cover back on and
close it, (see illustration i).
^ Tighten the locking screws. If the
bristles are totally worn out, a
replacement roller brush can be
purchased through your Miele Dealer
or the Spare Parts Dept.
Replacing the drive belt
(illustrations j and k)
The housing must be opened to fit a
new drive belt.
^ Remove roller cover a (as already
described) and lift roller brush b off
its supports.
^ Unscrew fixing screws c from the
brush base section d, and separate
the base section from top section e.
^ Fit a new drive belt.
^ Reassemble the Electrobrush by
reversing the procedure.
Replacing the connection
cable
If the connection cable for this
appliance is damaged it must be
replaced by a connection cable
specifically designed for this
appliance. Please contact your
Miele dealer, or the Miele Spare
Parts Dept.