Carrera RC 370503018 Instrucciones De Montaje página 21

4. Forwards / backwards
right / left banking
5. Trimmer for right / left banking
6. Trimmer for forwards / backwards
7. Trimmer for rotation
8. Looping Button
9. Headless Mode
10. Start rotor' button
11. 'Auto-landing' button
12. 'Auto-start & fly to 1.5 m' button
13. "LED lights ON/OFF" button
14. Beginner/Advanced switch
(30%/60%/100%)
15. Adaptable tablet holder – button for
adjusting the controller's width
16. Knob for camera angle adjustment
7 17. Battery compartment
Choosing the flight area
12 The Quadrocopter may be flown out-
doors. When you have trimmed your
Quadrocopter properly and are thor-
oughly familiar with its controls and how
it can perform, you can then start to fly it
in smaller and more confined spaces.
Please be aware that, although it may be
calm on the ground, it may still be very
windy even a little way off the ground. If
this warning is disregarded, it may lead
to total loss of the Quadrocopter.
Checklist for flight preparation
This checklist is not a substitute for the con-
tents of the operating instructions. Although it
can be used as a quick-start-guide, we strong-
ly recommend you first to read the operating
instructions in detail before you proceed.
• Check the contents of the package.
• Fit the landing feet and the camera as de-
scribed under
2
• Fix your portable phone or tablet to the con-
troller .
4 5
• Charge the lipo-battery as described in the
section "Recharging the LiPo rechargeable
battery".
.
3
• Fit 2 AAA batteries in the controller, making
sure their polarity is correct.
• Look for a suitable environment for flying.
• Read and comply with the legal and safe-
ty regulations governing the use of your
Quadrocopters.
• Slide the battery into the battery bay on the
bottom of the Quadrocopter.
• Switch the model ON at the ON/OFF switch.
• WARNING! Immediately after switching it
on, place the Quadrocopter on a flat and
level surface. The gyro-system will then
set itself automatically.
• The LEDs on the quadrocopter now flash
rhythmically
• Switch on the controller at the ON/OFF
switch. Be sure to check the Beginner-Ad-
vanced switch (
joystick, i.e., the throttle control, completely
upwards and then completely downwards.
• Allow the Quadrocopter a few moments un-
til the system is correctly initialised and is
ready for operation. The LED in the Quadro-
copter now lights continuously. The LED on
the controller now lights continuously.
• Repeat the above points as required, if you
wish to fly more Quadrocopters at the same
time.
• Bind your smartphone as described in point
with the Quadrocopter until you see the
18b
camera live picture on the screen. Furhter
details on functions on the camera see point
.
18 18a 18b
• Important note! Please perform the au-
to-trimming
23
fail!
• Start the Quadrocopter by means of
pressing on the 'Start rotors' key.
• Check the control system.
• Make yourself familiar with the control system.
• Trim the Quadrocopter as necessary as
described under
hovering it no longer moves from the spot
without a command from the controller.
• The Quadrocopter is now ready to be flown.
• If the Quadrocopter displays no functions,
retry the above binding procedure.
21
ENGLISH
6b
). Push the left-hand
17c
before each flight without
, so that when
23 24 25 26