Contents Of Package - Carrera RC 370503018 Instrucciones De Montaje

• Always recharge the battery immediately
after use to prevent its becoming deep
discharged. Please make sure to allow a
pause of about 20 minutes between fin-
ishing the flight and recharging the bat-
tery. Recharge the battery occasionally
(suggested every 2-3 months). Failure to
treat the battery as described above can
lead to its becoming defective.
• When transporting or temporarily storing the
rechargeable battery the temperature should
be between 5-50°C. If possible, do not store
the battery or the model in a car and do not
expose it to direct sunlight. In case the battery
is broiled it can be damaged or catch fire.
Note: If the battery voltage/output is low you
will recognise that a considerable trim and/
or controlling is necessary to avoid that the
Quadrocopter starts trundling. This usually
occurs before reaching a battery voltage of
3 V and it is a good moment to end the flight.
Instruction Manual

Contents of package

1 1 x Quadrocopter
1 x Adjustable controller
1 x USB charging cable
1x 3,7 V 1000 mAh Rechargeable Battery
1 x Camera
1 x Landing feet including screws
1 x Table holder
2 x Replacement motor (right/left)
1x Screwdriver
2 x AAA LR03 batteries (non-rechargeable)
Fixing of the landing feet and the
camera
2 Using the screwdriver, fix the four landing
feet on the underside of the Quadrocopter,
as shown in the illustration.
3 Place the camera in its central mounting
underneath the Quadrocopter. Plug the
three-wire plug in the left-hand and the
five-wire plug in the right-hand socket next
to the mounting.
Fixing the portable phone
4
A portable phone can be fixed between
both sides of the controller. Press the but-
ton in the middle of the controller for this
purpose, in order to change the width in
such a way that the portable phone is
clamped and it cannot slip out of position.
Mount the table holder
5
if you want to use a tablet in your control-
ler, then we recommend that you mount
the supplied holder for reasons of safety.
Push the holder onto the middle of the
1
controller's back until it engages.
The holder's length can be set with the
2
adjusting wheel. Fix the holder in such a
way that the tablet is firmly clamped onto
the controller.
Recharging the LiPo rechargeable
battery
Make sure you only charge the LiPo recharge-
able battery supplied with the LiPo charging
unit also supplied (USB cable and remote
control). If you try to charge the rechargeable
battery with a different LiPo battery charger
or any other battery charger, this might cause
serious damage. Please carefully read the
previous chapter with warnings and guide-
lines on the usage of rechargeable batteries
before proceeding. Supply terminals are not
to be short-circuited.
You can charge the rechargeable battery fit-
ted in the Quadrocopter with its USB charging
cable from a USB port on a computer:
6a Charging via computer:
• Rechargeable batteries are to be removed
from the model before being charged.
• Connect the USB charging cable with the
USB port of a computer. The LED on the
USB charger cable lights green indicating
that the charger unit is correctly connected
to the computer. If you plug in a Quadro-
copter with a discharged battery, the LED
19
ENGLISH