Ordering Replacement Parts; Disposal And Recycling - EINHELL GP-PM 51 VS B&S ECO Manual De Instrucciones Original

Anleitung_GP_PM_51_VS_BS_ECO_SPK7__ 10.09.12 16:24 Seite 29
8.4 Preparing the lawn mower for transportation
1. Drain the gasoline tank with a gasoline draw
pump.
2. Allow the engine to run until all gasoline residue is
used up.
3. Drain the engine oil while the engine is still warm.
4. Disconnect the spark-plug connector from the
spark plug.
5. Clean the casing.
6. Remove the starter cable from the lug (Fig. 5/Item
23). Release the quick release at the push-bar
and fold the push-bar down as shown in Fig. 21.
Make sure that the cords do not get kinked when
the bar is pulled up.
7. Wind several layers of corrugated cardboard
around the upper and bottom push-bar and the
engine to prevent chafing.

8.5 Ordering replacement parts

Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

9. Disposal and recycling

The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
29