Suggested Pile Height Settings - Sears Kenmore 116.22614 Manual De Uso Y Cuidado

3. Lower handle from upright position by
pressing on the handle release pedal.
Handle
4. Select a pile height setting by pressing
the small pedal on the rear of the
PowerMate. The pile height setting shows
on the indicator.
SUGGESTED PiLE HEIGHT
SETTINGS:
For best deep down cleaning, use the XLO
setting. However, you may need to raise the
height to make some lobs easier, such as
scatter rugs and some deep pile carpets,
and to prevent the vacuum cleaner from
shutting off. Suggested settings are:
HI - Shag, deep pile, or scatter rugs.
MED - Medium to deep pile.
LO - Low to medium pile.
XLO - Most carpets and bare floors.
Attention: Refer to your carpet
manufacturers cleaning recommendations.
Some more delicate carpets may require
that they be vacuumed with the PowerMate
agitator turned off to prevent carpet
damage.
CAUTION
DO NOT leave the PowerMate running
in one spot in the upright position for
any length of time. Damage to carpet
may occur.
5. Select a switch position on the handle.
OFF - turns off
both the canister
and the
PowerMate motors.
FLOOR - turns on
the canister motor
only.
CARPET - turns on
both the canister
and the
PowerMate motors.
NOTE - When this
switch is in the
FLOOR position,
the headlight
DOES NOT
function since no
electricity flows to
the PowerMate.
OFF
FLOOR
..CARPET
TELESCOPING WAND
The telescoping wand length is adjustable
and requires no assembly. To adjust,
simply push down on the wand adjust
button and slide the upper portion of the
telescoping wand to the desired height.
NOTE: When adjusting the telescoping
wand length you may have to hold the
PowerMate with your hand or foot.
m
m
m
-- Keep Hand
AboveThis
Tab
m
m
-11 -