Publicidad
Idiomas disponibles
Idiomas disponibles
PRE-FILTER CLEANING
To Reinstall:
The pre-fitter
is located
inside the dust
cup.
Check the pre-filter
frequently
and
clean when dirty.
1. Remove the dust cup as outlined in the
DUST CUP CLEANING
(page
17).
NOTE:
Make
sure dust cup is free of
debris before
opening.
'2. Rotate
dust cup lid assembly
counterclockwise
as indicated
on the lid
and lift off.
Lid Assembly
LOCKED
(For Use)
3. Grasp
pre-fitter
and rotate
counterclockwise
to remove.
UNLOCKED
(For Cleaning)
4. Clean
pre-filter
by gently
tapping
over a trash
container.
Tap on
several sides to
ensure best
cleaning.
If necessary, rinse with cotd water only,
DO NOT use detergent or soap. Allow
parts to dry 24 hours before putting back
into vacuum cleaner.
DO NOT wash in the dishwasher.
DO NOT install damp.
1. Align
the slots
on the pre-fitter
with the
//.
alignment
tabs
inside dust cup
,//_
lid assembly.
'2. Rotate
pre-
filter
clockwise
to lock in
place.
-Tabs
Slots
3. Replace
the lower
portion of the dust
cup by aligning
marks as shown,
UNLOCKED
(For Cleaning).
UNLOCKED
(For Cleaning)
LOCKED
(For
Use)
4. Rotate
while
pressing
downward
until
marks align as shown; LOCKED
(For Use).
5. Reinstall
the dust cup.
See DUST CUP
CLEANING
(page
17).
-18-
Publicidad
