AEG SWD81800G1 Manual De Instrucciones página 11

Problem
The appliance does
not operate. The
lamp does not oper-
ate.
The lamp does not
work.
The compressor op-
erates continually.
Water flows on the
rear plate of the ap-
pliance.
Water flows into the
appliance.
Water flows on the
ground.
The temperature in
the appliance is too
low.
Possible cause
The appliance is switched
off.
The mains plug is not
connected to the mains
socket correctly.
The appliance has no
power. There is no volt-
age in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not
set correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
During the automatic de-
frosting process, frost de-
frosts on the rear plate.
The water outlet is clog-
ged.
Products prevent that wa-
ter flows into the water
collector.
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regula-
tor is not set correctly.
ENGLISH
Solution
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the
door".
Do not keep the door
open longer than necessa-
ry.
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Decrease the room tem-
perature.
This is correct.
Clean the water outlet.
Make sure that products
do not touch the rear
plate.
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
11