Operation - Greenlee GATOR ES1000 Manual De Instrucciones

Operation

Electric shock hazard:
This tool is not insulated. When using
this unit near energized electrical
lines, use proper personal protective
equipment.
Failure to observe this warning could
result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
Do not cut steel.
Failure to observe this precaution may result in injury
or property damage.
1. Activate the switch to open the movable blade.
2. Place the cable to be cut onto the stationary blade
and close the movable blade around the cable.
Feed the movable blade by hand so that the gear
teeth engage the drive mechanism of the tool.
3. Slide the direction control lever to FORWARD.
Press and hold the trigger switch until the cable is
completely cut.
4. Slide the direction control lever to the center (LOCK)
position.
5. When finished, remove any dust or particles that
may have become attached to the brush.
Circuit Breaker
The following may cause the circuit breaker to trip:
• Cutting material that is too large
• Cutting material that is too hard
• Overheating due to continuous use
• Drawing excessive current
If the circuit breaker trips, the tool will stop. If necessary,
allow the tool to cool down. Press the RESET button.
(Wait 10 seconds to one minute before resetting.)
Greenlee / A Textron Company
ES1000 Battery-powered Cable Cutter
Removing the Battery
Do not dispose of battery in a fire. The battery will
vent harmful vapors and can explode.
Failure to observe this warning could result in severe
injury or death.
1. Press the battery latch on the battery.
2. Pull the battery down and out of the tool.
Charging the Battery
Do not connect the charger to a generator. Voltage
fluctuations can damage the charger.
Failure to observe this precaution may result in injury
or property damage.
The battery charger will recharge the battery in approxi-
mately one hour.
1. Set the charger on a firm level surface out of direct
sunlight. Be sure that the charger's ventilation slots
are not blocked.
2. Connect the charger to an appropriate power
supply.
3. Insert the battery into the battery pocket of the
charger. The red LED will light to indicate that the
battery is charging. The red LED turns off and
the green LED turns on when the battery is at
80% capacity. To reach 100% capacity will take
approximately 13 to 15 hours after the green LED
switches on.
Note: It is acceptable to use the battery after the
red LED turns off and the green LED turns on.
4. Remove the battery from the charger.
Note: Allow the charger to cool for at least 15 minutes
before charging another battery.
7
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070