For Your Safety - Bosch ART ACCUTRIM Serie Instrucciones De Servicio

F016 L70 348 - GB Seite 3 Donnerstag, 10. November 2005 10:11 10

For Your Safety

Warning! Switch off, remove battery from ma-
chine before adjusting or cleaning.
The blade continues to rotate for a few sec-
onds after the trimmer is switched off.
Caution – do not touch rotating blade.
Charging Procedure
The charging procedure starts as soon as the mains
plug is plugged into the socket and the battery 13 is
inserted into the charging compartment 16.
Due to the intelligent charging method, the charging
condition of the battery is automatically detected and
the battery is charged depending on battery temper-
ature and voltage.
This gives longer life to the battery and always
leaves it fully charged when kept in the charger for
storage.
Control of the charging procedure is indicated via
the charge control LED 14:
Rapid charging
The rapid-charging procedure is in-
dicated by flashing of the charge
control LED 14.
The battery is fully charged as soon as the LED 4
switches from flashing to being lit continuously. Af-
terwards the battery can be removed for immediate
use.
It is recommended not to remove the battery until the
battery is fully charged.
☞
The rapid-charging procedure is possible only
when the temperature of the battery is be-
tween 0 °C and 45 °C.
Trickle charging
The trickle-charging procedure is in-
dicated by continuous lighting of
the LED 4.
With the battery fully charged, the charger immedi-
ately switches to trickle-charge mode. This equal-
izes the natural running-down of the battery again.
17 • F016 L70 348 • TMS • 08.09.05
Charging Advice
With continuous or several repetitive charging cy-
cles without interruption, the charger can warm up.
This is not harmful and does not indicate a technical
defect of the unit.
A battery that is new or has not been used for a
longer period does not develop its full capacity until
after approximately 5 charging/discharging cycles.
A significantly reduced working period after charging
indicates that the batteries are worn out and must be
replaced.
Assembly
Do not connect the battery before product
is completely assembled.
Ensure product is assemble in the following or-
der:
Mounting the Cutting Guard
A
Place the cutting guard 10 on the trimmer head 8.
➊
Hook the guard onto trimmer head and push until
secure fitting.
➋
Push rear of guard until secure (click).
Mounting the Wheels (ART 26/2600 ACCUTRIM
only)
Fit the wheels 11 onto the shaft 6.
B1
Fit the bolt 19 and the wingnut 18.
B2
Note: The position of the wheels can be adjusted by
loosening the wingnut 18 and moving to the desired
position.
The wheels can be moved up and down the
B3
shaft 6 depending on the height of cut required.
Fitting Cutting Disc/Fitting Blade
Press cutting disc 20 onto drive adaptor as
C
shown (click).
Fit the blade, place the blade 22 over the
D
pivot 21 and pull outwards until it snaps into place.
English - 3