König Electronic SEC-ALARM210 Manual De Uso página 6

beeping indications. Please select in which zone you need to program the motion detection sensor
before proceeding further.
Repeat step 1 and 2 of the previous chapter to start the synchronising process.
Step 3:
Activate the motion detection sensor by pressing the "Test Button" on the back of the motion detection
sensor.
Note:
You may program up to 4 sensors to one zone. Zone 4 is an alert zone. Sensors in this zone are for
alert purpose ONLY and will not trigger the alarm.
Step 4:
After programming the motion detection sensor to the control centre, you may place the control centre
in test mode to verify the communication between the motion detection sensor and the control centre.
1) Remove the adapter and all batteries from the control centre.
2) Press and hold the "Mute Button" and plug the AC adapter back into the control centre. All LED
indicators will be ON; you may release the "Mute Button". The control centre is now in "Test Mode",
and it will respond to all motion detection and other sensors.
3) Place the type of alert switch to "Alert" and you may now activate the motion detection sensor by
pressing the "Test Button" of the motion detection sensor. You may also move in front of the motion
detection sensor. Please refer to step 6 for detailed information on how to walk to test the motion
detection sensor.
4) The control centre will respond by flashing the zone indicator and alert beeping, according to the
zone number. 1 beep for zone 1, 2 beeps for zone 2 etc. The beeping will last around 15 seconds
for each activation. After testing, unplug the adapter and plug it back into the control centre; it will
return to normal operating mode.
Step 5:
You may now close the battery cover
and re-insert the screw. Mount the
ball-head joint on the wall with screws
provided. Slide the back of the sensor
into the ball-head joint. The mounting
angle can be adjusted.
Press Control centre "long beep".
"Test Button"
6
Zone indicator OFF.
You will hear a long beep and the zone
indicator stops flashing. The sensor is now
programmed to the control centre