Care And Maintenance - Bosch SHX46L Manual De Instrucciones

USING YOUR DJSHWASHER...cont. CARE AND MAINTENANCE
DISHWARE DAMAGE: Delicate or
heirloom items can be damaged
in a dishwasher. Do not wash
delicate or heirloom items in your
dishwasher if there is any
possibility of damage to such
items.
d) For delicate or heirloom dishware
and silverware, or other special items,
select Delicate/Econo after referring to
the Materials section of this manual.
Hand-washing may be the best
treatment of such items.
More information on Bosch
dishwasher cycles is in the Wash Cycle
Information section of this manual.
2. Starting the Dishwasher
a) Open the dishwasher door far
enough to expose the control buttons.
b) Press the On/Off button.
c) Press the button for the desired
wash cycle.
d) Shut the dishwasher door.
e) The dishwasher will start
automatically and continue operating
until the end of the selected cycle.
Once you start the dishwasher, leave
the dishwasher door shut until it
finishes the cycle.
3. Interrupting a Cycle
NOTE: Shoutd you need to interrupt a
cycle (to add or remove an item, to add
detergent, etc.), it is best to do so within
the first 30 minutes of the cycle.
a) Open the dishwasher door far
enough to expose the control buttons.
b) Press the On/Off button.
SCALD HAZARD: You coutd be
seriously scalded if you open the
dishwasher door quickly during a
wash or rinse cycle. Do not fully
open the dishwasher door for at
least 10 seconds or until water
noises stop.
J
c) Wait at least ten seconds or until
water noises stop before opening the
dishwasher door.
d) To resume the cycle, press the On/
Off button and shut the dishwasher door.
4. Canceling or Changing a Cycle
a) Open the dishwasher door far
enough to expose the control buttons.
b) To cancel or change a cycle, press
and hold for three seconds the two
buttons labeled "Cancel Drain" as
shown in Figure 19.
Figure 19
o _ Cancel D rain_ ®
c) Wait approximately one minute, then
press the On/Off button
d) You may now begin a new cycle.
Dishware Drying
NOTE: Check the Dishwasher Options
section of this manual for information on
the Additional Drying Heat option.
At the end of the cycle the dishwasher
wiII stop and a period of condensation
drying will folIow. After 12 - 15 minutes of
drying,
,, The CycIe Completion SJgnaI wJJJ
sound,
,, the "Sanitized" symboI will appear
(except in the Rinse and HoId cycle).
NOTE: If your household water supply
is too hot, your dishwasher's heating
time may be reduced and the "Sanitized"
light may not illuminate. Your Bosch
Dishwasher Installation Manual has
information on the recommended
temperature for your household hot water
supply.
NOTE: To accelerate and enhance
drying, open the dishwasher door, pull
the top rack a few inches out of the
dishwasher, and prop the dishwasher
door against the top rack.
- The "Sanitized" Indicator
The Sanitized Indicator is a symbol that
appears on the display as shown in
Figure 20.
When the Figure 20
"Sanitized" symbol
appears, it means
that the dishware
and kitchenware
that was just
washed has been
sanitized
according to the
requirements of the Nationai Sanitation
Foundation (NSF). For more information
on NSF certification, go to the Wash
Cycle Information section of this manual.
- The Cycle Completion Signal
This Cycle Completion Signal is a tone
that sounds when your Bosch
dishwasher finishes washing and drying
your dishes. You can either disabie the
tone, or you can set it at one of two
volumes (your dishwasher leaves our
factory with the tone set on the lower
volume).
To change the Cycle Completion
Signal Volume:
a) Open the dishwasher door far
enough to expose the control buttons.
b) Press and hold down the Delay
On/Off button. When the tone begins to
sound and the display shows a 0, 1, or
2, reiease the buttons.
c) Press the Delay Start button untiI
the tone is either at the desired volume
or is sJIenL The dispIay will show a 0
(silent), 1, or 2 (loudest) for the volume
level.
d) Press the On/Off Button,
e) Shut the dishwasher door, The
Cycle Completion Signal is now set, and
you may wash your dishes as usual.
- Additional Drying Heat
With this option you can raise the
temperature of the rinse water, which will
resuIt in better and faster drying.
a) Press and hold the left "Cancel
Drain" button as shown in Figure 19,
then press and hoId the On/Off button.
When the LED display shows a "0" or
a "1", release both buttons. The light
above the left "CanceI Drain" button wJJJ
begin to flash.
b)To enable the Additiona! Drying
Heat, press the left "Cancel Drain"
button until the LED display shows a "1".
c)To disable the Additiona! Drying
Heat, press the left "Cancel Drain"
button untJI the LED display shows a "0".
d)Press the On/Off button. The light
above the left "Cancel Drain" button wJJJ
stop flashing. You may now wash
dishes as usual.
Unloading the Dishwasher
1. General Guidelines
a) Unload the bottom rack first.
b) UnIoad the silverware basket(s).
They are easiIy removed for unloading.
c) Unload the top rack.
d) If the Extra Tall Item Sprinkler was
installed, return the dishwasher to its
normal condition (see the Loading Extra
Tall Items instructions in the "Loading
the Dishwasher" section of this manuai).
CARE AND tVIAJNTENANCE
Maintenance Tasks
Certain areas of your Bosch
dishwasher require occasional
maintenance. The maintenance tasks
are easy to do and wil! ensure continued
superior performance from your Bosch
dishwasher. These tasks are:
,, Winterizing Your Bosch Dishwasher
,, Wiping up Spills and Splash-out
,, Clean the Stainless SteeI Inner Door
and Tub
,, Check/Clean the Spray Arm Nozzles
,, Check/Clean the Filter System
,, Clean the Exterior Door Panel
,, Clean the Door Gasket
2. Winterizing Your Bosch
Dishwasher
Start Button, then press and hold the