Arcora ANIKO 30 FOAMTEC Manual De Uso Y Mantenimiento página 18

to 8 bars) inside the air tank. To empty the air tank, spray air with the accessory, with both
compressor and pump switched off. Finally, switch on the compressor.
NOTE: The compressor is provided with a safety thermal protection, which intervenes to
protect it from an overheating. If the compressor stops suddenly, when the pressure or the
air has not yet reached its steady value, then it can be due to an overheating. If this
happens, check that the voltage supplied to the machine corresponds to the value indicated
on the label and that the set point for the air pressure is not too high. Switch off then the
compressor, empty the air tank and wait form some minutes before switching the
compressor on.
After foaming, it is necessary to leave the foam act for some minutes on the surfaces. If the
foaming step has required some minutes, the first surfaces to be foamed are ready to be
rinsed.
The time necessary for the chemical action might vary according to the type of surface and
to the type of dirt. For a wall with average-smooth panes, it should be enough to leave the
foam act for 2-3 minutes.
NOTE: We advise to wait the necessary time for the foam to perform its chemical action, in
order to obtain the maximum result. The time and water necessary for rinsing will be
therefore also reduced.
In order to perform the rinsing, it is necessary to commutate the machine from the "foam
mode" to "rinse mode", as follows:
1. Turn the lever of the FOAM/RINSE valve into the RINSE position
2. Verify that the pump is ON.
3. Press the lever on the accessory. We suggest to proceed rinsing the vertical surfaces
from the top to the bottom.
After rinsing, it is possible to remove the water residuals from the vertical surfaces (glass,
panes), using the tools provided with the machines (pane wiper and floor wiper with
extendable handle-tube usable with both).
TIME NECESSARY FOR THE CHEMICAL ACTION
STEP B – RINSING AND FINISHING
18