Zwilling ENFINIGY 53011 Manual De Instrucciones página 16

Fault
Fault
Problem
The display is showing
negative values.
The display is showing
implausible values.
The message "Err" appears
on the display.
The message "Lo" appears
on the display.
Unable to switch on scales.
16
Possible cause
The display has been reset to
zero for a container or to weigh
additional ingredients, and
the object not included in the
weight has been taken off
the scales.
The display is not showing the
expected unit of measurement.
The scales are including the
container in the weight on the
display.
The display is only showing the
additional weight, not the total
weight.
The load on the scales is too
heavy.
The battery is empty.
The battery is empty.
The battery is charging.
Remedy
Tap on the control panel to reset
the display to zero again.
Switch the display to the re-
quired unit of measurement.
Before weighing, place the
container on the scales and tap
on the control panel to reset the
display to zero.
The total weight is only shown
once it exceeds 400 g (tare
display) and you tap on the
control panel after adding an
additional weight.
Do not place more than a total
of 10 kg on the scales.
Charge the battery using the
USB connection on the scales.
Wait until charging is complete
or disconnect the USB charger
cable to abort the charging
procedure.
GB