Connecting The Power Supply; Connecting The Antenna; Preparing The Remote Control; Connecting The Headphones - Sonoro SO-210 Instrucciones De Manejo

1. Open the battery compartment cover on the
back of the device with a small coin (Fig. 7).
2. Insert the supplied battery with the label side
up.
3. Insert the battery compartment cover and close
with a small coin.

7.3 Connecting the power supply

Power is supplied to the device via the AC adapter
(included). The AC adapter with universal adapter
must be connected before use.
L WARNING!
Risk of injury from incorrect handling!
Risk of electric shock from improper handling of
the AC adapter with universal adapter.
– Make sure that the AC adapter and universal
adapter are always firmly connected to each
other.
– Pull the AC adapter straight out of the socket so
that the adapter does not break off the
mounting bracket.
L NOTICE!
Material damage occurs from an incorrect vol-
tage connection!
Connection values that exceed the maximum
allowable values of the device can destroy the
device.
– Only use the AC adapter (included).
– Only operate the device if the electrical voltage
indicated on the AC adapter matches the
voltage of your power outlet.
Fig. 8: Installing and disconnecting the universal
adapter
1. Slide the universal adapter onto the AC adapter
until it engages (Fig. 8).
2. Plug the AC adapter's connector plug on the
back of the device into the 15.5 V, 2.9 A DC port.
3. Plug the power plug into an electrical outlet.

7.4 Connecting the antenna

The antenna (included) is needed for radio reception
in the FM frequency range and for DAB radio stations.
1. Screw the FM/DAB antenna located on the back
of the device to the DAB/FM antenna connector.
2. Unfold and align the antenna so that you have
the best possible reception.
i
For good FM/DAB radio reception, the two ends of
the antenna should form a "T" (dipole) with the
connecting cable.
For even better reception, attach the cable to a
suitable house antenna.

7.5 Preparing the remote control

Fig. 9: Insert the battery into the remote control.
1. Open the battery compartment on the remote
control (Fig. 9).
2. Insert the supplied button cell (CR2032, 3 V)
with the label side (+) up.
3. Close the battery compartment.

7.6 Connecting the headphones

The headphones can be connected to the device with
the 3.5 mm stereo jacks (not included in the
package).
L WARNING!
Risk of injury from improper headphone use!
Improper use of headphones can lead to serious
injuries and health hazards.
– Do not set the volume too high when using the
headphones.
1. Turn the click wheel to the left to set the volume
to minimum.
83