Parallel Connection - Amate Audio KEY Serie Manual De Usuario

KEY Active systems
2.2. Configurations

2.2.1. Parallel connection

Connect the signal (mixing desk output) to INPUT on the first unit. Use the LINK
output to transfer the INPUT signal to the second unit and thus sequentially for
further units. All of the units in this chain must be switched on.
For the mains connection use the cable with the blue PowerCon.
Do not connect KEY series units using PowerCon without earth.
Fig.2. Parallel connection for KEY cabinets
2.2.2 Parallel connection with subwoofer
You can connect the KEY subwoofers in parallel with KEY full range cabinets.
Please, follow the same parameters as explained in figure 2.
3. MOUNTING AND PLACEMENT
For a proper installation of the acoustic cabinet systems, it is strongly recommended
to carefully read the following advices.
3.1. Placement
10
The Full Range cabinets should be located in a high
position (between two or three meters), slightly inclined to
the audience. If the loudspeakers are located too low, the
listeners at the end of the room will not hear a good sound
quality.
Fig.3. Flying placement
Sep 2018
Amate Audio