Parts And Components; Before Use - cecotec Conga WinDroid 870 Connected Manual De Instrucciones

ENGLISH

1. PARTS AND COMPONENTS

Fig. 1
1. Light indicators
Flashing red light: error:
Blue light on: operating
Green light on: fully charged
Red light on: charging
White light on: Connected to the power supply
2. Buzzer
3. Hooking hole
4. Air vent
5. Power connector
6. Power switch
7. Hooking hole
8. Bottom light indicator:
Flashing red light: Error
Red light on: Correct operating
Fig. 2
Remote control
1. Automatic up and down
2. Automatic left and right
3. Automatic right and down
4. Stop cleaning
5. Pause cleaning
6. Up manually
7. Down manually
8. Right manually
9. Left manually
10. Start cleaning

2. BEFORE USE

Take the product out of the box and remove all packaging material.
Make sure all parts and accessories are present and in good conditions. If not, contact
immediately the Technical Support Service of Cecotec.
Check if the safety rope is broken or the knot is loose. Fasten the safety rope and tie to indoor
fixture before operating the device.
Make sure the battery is fully charged (green light indicator on).
34
Turn the robot on before putting it onto the glass. Once on the glass, make sure it remains
stuck before letting it go.
Remove anything on the glass.
Note: before operating the remote control, remove the insulation spacer at the bottom of the
back side. To remove or change the battery, just slide downwards the battery cover. Pull and
lift to open the filter cover.
Warning
It is advisable to supervise the robot during its first usage to ensure that its operating on the
surface is the correct one. If willing to clean a surface with a certain pecularity and you are not
sure if the robot will work correctly, extreme surveillance and precautions. Keep in mind that
the safety cord must be always used.
Conga WinDroid 870 has been designed to clean all kind of windows in houses and shops and
also standardized vertical flat surfaces.
It is recommended to use the product under these circumstances for safety reasons:
Do not use the robot for cleaning glasses without a frame.
Do not use the robot for cleaning curved glasses, concave or convex.
It is not suggested to use it on glasses thinner than 3 mm.
Do not use the robot in glasses with a sealing gasket (silicone or rubber) between the frame
and the glass with these characteristics: if the gasket has an angle (ɑ) inferior to 45º and its
distance to the edge (lb) is bigger than 5 mm, the robot might loose stickness properties and
fall. If the window's sealing gaskets fit these characteristics, do not use the robot vacuum
cleaner.
3. OPERATION
Important: the robot must always be connected to the power supply in order to operate.
Power connection
Connect the power cord to the power supply and then to the robot.
Tighten the screw.
Fig. 3
On/off
Hold pressed the power button for 2 seconds to turn the device on or off.
During operation, press the power button to pause or start cleaning.
Fig. 4
Placing the Conga WinDroid robot on the glass/window
Turn the robot on and make sure the fan starts running.
ENGLISH
870 CONNECTED 35